Categories
Contact Us
Jiangsu Lopal Tech Co.,Ltd
Add:NO.6 Hengtong Avenue, Economic and Technological Development Zone, Qixia District, Nanjing City, Jiangsu Province
Tel:+86-025-85802178
Fax:+86-025-85804898
Mobile:+86-13677379280
E-mail:caoyuepeng@lopal.cn
Knowledge
Home > Knowledge > Content
Inspection method of lubricating oil
Nov 06, 2017

Check the oil cover

Unscrew the filler lid and turn it over to see the bottom, which can be seen on the bottom of the refueling lid and traces of the old oil or even dirty oil. If the bottom surface of the refueling mouth has a layer of dark emulsion with a sticky consistency, there is a small water droplets mixed with oil, this is not normal situation, may be the cylinder pad, cylinder head or cylinder body damage, resulting in the cooling fluid into the lubricating oil. If this happens, the contaminated lubricant will cause harm to the internal engine and it needs to be overhauled.

Second, check the amount of lubricating oil

If the refueling mouth cover is no problem, then find the lubricant ruler, then pull it out, first check the oil surface, the oil surface height should be in the "full" or "fully" position.

If the oil surface is too low, will damage the engine due to poor lubrication, but also to the valve, cylinder pads, piston ring damage. Inspect the bottom of the car to see if there is leakage of lubricating oil, if there is a condition to detect the pressure of the cylinder, whether there is leakage and damage to the engine parts.

Third, through the exhaust inspection

If the exhaust is blue smoke, indicating valve oil seal failure, lubricating oil into the cylinder combustion chamber, may also be the piston ring and cylinder wall clearance too large or piston ring fault, etc. or due to the engine oil seals and oil seal aging and damage, resulting in oil leakage, excessive consumption of lubricating oil.

IV. Color of lubricating oil

Can take out a paper towel, pull out the lubricating oil ruler to wipe on the sheet, observes the lubricating oil color and the impurity condition. Generally after the lubricating oil, the vehicle used for a period of time after the lubricant will become black, this is normal. Other colors are abnormal. If the color of the lubricating oil is found to be gray, white or emulsifying, it is indicated that the lubricating oil is mixed with water. It is possible that the engine cooling system and the combustion system have connected leakage.


  • Newsletter
  • Categories
  • Contact Us
    Jiangsu Lopal Tech Co.,Ltd
    Add:NO.6 Hengtong Avenue, Economic and Technological Development Zone, Qixia District, Nanjing City, Jiangsu Province
    Tel:+86-025-85802178
    Fax:+86-025-85804898
    Mobile:+86-13677379280
    E-mail:caoyuepeng@lopal.cn
  • QR Code
  • Copyright © Jiangsu Lopal Tech Co.,Ltd All Rights Reserved.